Guest

Cisco Small Business Voice Gateways and ATAs

Enabling WAN Web Server on SPA2100

Document ID: 108797

Updated: Dec 12, 2008

   Print

Contents

Introduction
How do I enable WAN Web Server on SPA2100?
Related Information

Introduction


This article is one in a series to assist in the setup, troubleshooting, and maintenance of Cisco Small Business products (formerly Linksys Business Series).

Q. How do I enable WAN Web Server on SPA2100?

A.

There are two ways to enable WAN Web Server on SPA2100. This may be done through SPA2100's web-based interface or through the Interactive Voice Response (IVR) menu.

Enabling WAN Web Server Through SPA2100's Web-Based Interface

Step 1:
Access SPA2100's web-based interface. For instructions, click?here.

Step 2:
When the SPA2100's web-based interface appears, click Admin Login then advanced on the upper right-hand page.

Note: Access to the SPA2100's Admin Login-Advanced page does not require a password. SPA2100 units acquired through VoIP providers, however, are generally use password for security reasons. This will deny access to the Admin Login and reject changes applied to existing voice configuration. If the unit is purchased from a reseller, it can be restored to default settings through factory reset using the IVR. For IVR instructions, click?here.

Step 3:?
Go to WAN Setup, look for Remote Management and set Enable WAN Web Server to Yes.

Step 4:

Click?.

Enabling WAN Web Server through SPA2100's Interactive Voice Response (IVR)

Step 1:?
Dial ****201# on an analog phone connected to SPA2100.

Step 2:
Enter "1" to enable or "0" to disable the feature.

Related Information

Updated: Dec 12, 2008
Document ID: 108797