Guest

Cisco BPX/IGX/IPX WAN Software

Unable to Download BPX or IGX Card Firmware (getfwrev) from Cisco WAN Manager

Cisco - Unable to Download BPX or IGX Card Firmware (getfwrev) from Cisco WAN Manager

Document ID: 10787

Updated: Nov 22, 2006

   Print

Introduction

This document describes why you are unable to download BPX or IGX card firmware (getfwrev command) from a Cisco WAN Manager and a fix to enable the download.

Prerequisites

Requirements

There are no specific requirements for this document.

Components Used

This document is not restricted to specific software and hardware versions.

Conventions

Refer to Cisco Technical Tips Conventions for more information on document conventions.

The network_id Field

If the "network_id field" within config.sv is greater than 15, the getfwrev command does not download from the Cisco WAN Manager workstation. In this case, the dspdnld command shows the firmware version as unavailable.

This is fixed in SV_Rel7.2.5.Patch1.tar, which is available through from Cisco Technical Support. With this patch installed, the "network_id" can be set to a maximum value of 254.

An example config.sv is 0|Network1|sanfran|19200|0|7|3|0|30|256. The first field, containing 0, is the "network_id".

Related Information

Updated: Nov 22, 2006
Document ID: 10787