Cisco 1700 Series Modular Access Routers

WIC-1T One-Port Serial WAN Interface Card Cable Specifications

Cisco - WIC-1T One-Port Serial WAN Interface Card Cable Specifications

Document ID: 46793

Updated: Jul 07, 2005



This document provides cable specifications for the WIC-1T one-port WAN interface card.



There are no specific requirements for this document.

Components Used

This document is not restricted to specific software and hardware versions.

The information in this document was created from the devices in a specific lab environment. All of the devices used in this document started with a cleared (default) configuration. If your network is live, make sure that you understand the potential impact of any command.


For more information on document conventions, see the Cisco Technical Tips Conventions.



The WIC-1T features the Cisco 5-in-1 connector which supports several serial protocols (V.35, X.21, RS-232, RS-449, RS-530) when used with the appropriate transition cable. This facilitates easy configuration and re-configuration as network requirements change without the need to purchase a different serial interface card.

Note: When used in Cisco 1720 and 1600 Series Routers, the WIC-1T may also be operated in asynchronous mode. The WIC-1T is not supported in asynchronous mode when used in Cisco 2600 and 3600 Series Routers.

Cisco 5-in-1 Cables

Cisco 5-in-1 (DB-60 pin) cable support includes the following:

Related Information

Updated: Jul 07, 2005
Document ID: 46793