Guest

Cisco Video Surveillance Services Platforms

Recovery Procedure for Converged Infrastructure Video Security Device

Document ID: 91372

Updated: Apr 13, 2007

   Print

Introduction

This document explains the recovery/repair procedure for the Converged Infrastructure Video Security Device.

Prerequisites

Requirements

There are no specific requirements for this document.

Components Used

This document is not restricted to specific software and hardware versions.

Conventions

Refer to Cisco Technical Tips Conventions for more information on document conventions.

Recovery Procedure

This is the step-by-step recovery procedure:

  1. Connect an external USB drive, and boot the box with the Gold CD.

  2. Log on as root with the password cledne.

  3. At the prompt, run these commands:

    umount -f /dev/sda1
        umount -f /dev/sda2 
        fsck.ext3 -f -yC 0 /dev/sda1    ==> It should take a few minutes.
        fsck.ext3 -f -yC 0 /dev/sda2    ==> Will take some time (an hour or two)
    
  4. When it is finished, run this command:

    reboot
    
  5. The box starts to reboot. Remove the USB CD cable from the box, and let the box boot from itself.

Related Information

Updated: Apr 13, 2007
Document ID: 91372