Guest

IP Tunneling

Serial Tunneling (STUN) Complex Multipoint

Document ID: 12276

Updated: Sep 09, 2005

   Print

Introduction

This document provides sample configurations for Serial Tunneling (STUN) Complex Multipoint.

Prerequisites

Requirements

There are no specific requirements for this document.

Components Used

This document is not restricted to specific software and hardware versions.

Conventions

Refer to Cisco Technical Tips Conventions for more information on document conventions.

Configure

In this section, you are presented with the information to configure the features described in this document.

Note: Use the Command Lookup Tool (registered customers only) to find more information on the commands used in this document.

Network Diagram

This document uses this network setup:

18-1.gif

Configurations

This document uses these configurations:

Router Configurations
Router A
stun peer-name 1.0.0.1 
stun protocol-group 9 sdlc 
stun protocol-group 13 sdlc 
interface serial 0 
encapsulation stun 
stun group 9 
stun route address c1 tcp 5.0.0.1 

interface serial 1 
encapsulation stun 
stun group 13 
stun route address c1 tcp 7.0.0.1 

interface loopback 0 
ip address 1.0.0.1 255.255.255.0 
Router B
stun peer-name 5.0.0.1 
stun protocol-group 9 sdlc 
interface serial 0 
encapsulation stun 
stun group 9 
stun route address c1 tcp 1.0.0.1 

interface loopback 0 
ip address 5.0.0.1 255.255.255.0 
Router C
stun peer-name 7.0.0.1 
stun protocol-group 13 sdlc 
interface serial 1 
encapsulation stun 
stun group 13 
stun route address c1 tcp 1.0.0.1 

interface loopback 0 
ip address 7.0.0.1 255.255.255.0 

Note: WAN configurations and IP routing configurations are not shown (for simplicity). Also, serial interfaces require clocking by the DCE device. Encoding (NRZ/NRZI ) on STUN Interfaces must match end device encoding - router defaults to NRZ.

Verify

There is currently no verification procedure available for this configuration.

The Output Interpreter Tool (registered customers only) (OIT) supports certain show commands. Use the OIT to view an analysis of show command output.

Troubleshoot

There is currently no specific troubleshooting information available for this configuration.

Related Information

Updated: Sep 09, 2005
Document ID: 12276