Tidal Enterprise Orchestrator: Configuration of JMX Adapter for WebLogic Server

Available Languages

Download Options

  • PDF     (7.1 KB)
    View with Adobe Reader on a variety of devices
  • ePub     (84.5 KB)
    View in various apps on iPhone, iPad, Android, Sony Reader, or Windows Phone
  • Mobi (Kindle)     (70.6 KB)
    View on Kindle device or Kindle app on multiple devices
Updated:October 25, 2011
Document ID:113280

Bias-Free Language

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.

    Introduction

    This document describes the needed configuration steps to link the JMX adapter to WebLogic Servers.

    Prerequisites

    Requirements

    There are no specific requirements for this document.

    Components Used

    The information in this document is based on Tidal Enterprise Orchestrator 2.2+ and WebLogic.

    The information in this document was created from the devices in a specific lab environment. All of the devices used in this document started with a cleared (default) configuration. If your network is live, make sure that you understand the potential impact of any command.

    Conventions

    Refer to Cisco Technical Tips Conventions for more information on document conventions.

    Weblogic Servers

    These details required configuration.

    Procedure

    Complete these steps:

    1. On the WebLogic server the bottom line should be added to the setdomainenv.cmd or setdomainenv.sh. Port 9999 is used but that can be any unique number.

    2. Set JAVA_OPTIONS=%JAVA_OPTIONS% -Dcom.sun.management.jmxremote -Dcom.sun.management.jmxremote.port=9999 -Dcom.sun.management.jmxremote.ssl=false -Dcom.sun.management.jmxremote.authenticate.

    3. In the TEO configuration for the JMX adapter, this should be the override. Replace host with the host of the WebLogic server and the port with the same one used in the setdomainenv, service:jmx:rmi:/host/jndi/rmi://lhost:port/jmxrmi.

    Related Information

    Was this Document Helpful?

    FeedbackFeedback

    Contact Cisco

    This Document Applies to These Products