Guest

Cisco CSS 11500 Series Content Services Switches

How to Rerun the Setup Script on the CSS 11000/11500

Document ID: 12642

Updated: Dec 27, 2007

   Print

Introduction

This document provides information on rerunning the setup script on the CSS 11000 and 11500 series content services switches.

Prerequisites

Requirements

There are no specific requirements for this document.

Components Used

The information in this document applies to:

  • all CSS 11000 and 11500 series content services switches

  • Cisco WebNS Software Release 2.06 and later

The information in this document was created from the devices in a specific lab environment. All of the devices used in this document started with a cleared (default) configuration. If your network is live, make sure that you understand the potential impact of any command.

Conventions

For more information on document conventions, refer to the Cisco Technical Tips Conventions.

Information

The setup script runs the first time the CSS is booted. If there is no saved startup-config or archived startup-config, the CSS runs the setup script.

If you would like to rerun the setup script, you can perform one of these actions:

  • Clear the running config and issue the script play setup command.

  • Issue the clear startup-config and clear archive startup-config commands. Reboot the switch

Related Information

Updated: Dec 27, 2007
Document ID: 12642