Upgrading Cisco StadiumVision Mobile Software from Release 1.3 to Release 2.0
First Published: June 18, 2014
This module provides instructions for upgrading Cisco StadiumVision Mobile Reporter or Cisco StadiumVision Mobile Streamer software on both the Cisco UCS C220 and Cisco UCS C200 servers, and contains the following sections:
Before You Begin
Before upgrading, perform the following actions:
Cisco StadiumVision Mobile Streamer
– 1.3 to 2.0: SVM-STREAM-UPGRADE-2.0.0-xxx.x86_64_FOR-1.3.iso
– 2.0 to 2.0+: SVM-STREAM-UPGRADE-2.0.0-xxx.x86_64.iso
Cisco StadiumVision Mobile Reporter
– 1.3 to 2.0 or 2.0 to 2.0+: SVM-REPORT-UPGRADE-2.0.0-xxx.x86_64.iso
Upgrade Guidelines
When using a Cisco UCS C220 server, observe the following guidelines before starting the upgrade:
- Do not alter the RAID configuration prior to upgrading
- Verify the boot order in the BIOS (by pressing F2 while booting) prior to upgrading; the virtual DVD should be the primary boot device
Upgrade Tasks
The Cisco StadiumVision Mobile Reporter releases 1.2 and later, and Cisco StadiumVision Mobile Streamer releases 1.3 and later can be upgraded using a combination of the web browser user interface, and the TUI.
Beginning in Cisco StadiumVision Mobile Release 2.0, upgrades can be perform using the Software Manager (see the “Using the Software Manager to Upgrade Cisco StadiumVision Mobile Software” module).
To upgrade Cisco StadiumVision Mobile software, complete the following tasks:
Step 1 Navigate to the ISO Updater in a web browser, using the following address:
ip address /cgi-bin/isoupload.cgi
Step 2 Click on the Choose File button, navigate to the ISO file, and click the Upload ISO button.
The ISO image is copied to the hard drive.
Step 3 Access the TUI, using the procedure in the “Logging into the TUI” section.
Step 4 Go to the Server Administration > Server Upgrade menu.
Step 5 Choose the desired software upgrade from the list and press Enter.
The server begins the upgrade process.