Table Of Contents
B Commands
bios
boot
B Commands
The commands in this chapter apply to the Cisco MDS 9000 Family of multilayer directors and fabric switches. All commands are shown here in alphabetical order regardless of command mode. Please see the Command Mode section to determine the appropriate mode for each command. For more information, see the Cisco MDS 9000 Family Configuration Guide.
•bios
•boot
bios
To upgrade and verify the BIOS, use the bios command.
bios {program URI | validate URI | verify}
Syntax Description
program
|
Program the BIOS flash.
|
validate
|
Validate the BIOS source image.
|
verify
|
Verify the BIOS flash.
|
URI
|
The BIOS binary source filename in the supervisor. For example - bootflash:MC0210.BIN. The URI is always the BIOS source file's URI in the supervisor.
|
Defaults
None
Command Modes
EXEC/Module
Usage Guidelines
The BIOS source file must be downloaded into the supervisor before the bios program or bios validate commands can be used.
During the BIOS burn procedure, do not perform any configuration on the switch. In addition, do not perform a reload of the entire switch or any module.
Before the BIOS is programmed, the bios validate command can be run on the BIOS source file to validate it (optional).
After programming the BIOS, run the bios verify command to verify that the BIOS was programmed correctly (optional).
In case of programming failure, use the bios program command. If the failure persists, then problem lies with the BIOS flash hardware. If this is the case, the BIOS will fail to boot up if the module is rebooted.
Examples
module-2# bios program bootflash:MC0209.BIN
module-2# bios validate bootflash:MC0209.BIN
Verification succeeded ..
boot
To perform operations on the system, use the boot command.
boot [kickstart | system] [bootflash: | slot0: | tftp:] [sup-1 | sup-2]
Syntax Description
kickstart
|
Configure kickstart image
|
system
|
Configure system image.
|
bootflash:
|
System image URI
|
slot0:
|
System image URI
|
tftp:
|
System image URI
|
sup-1
|
The upper supervisor
|
sup-2
|
The lower supervisor
|
Defaults
None
Command Modes
Configuration
Usage Guidelines
The boot kickstart slot0:image command is currently not allowed. For kickstart, only bootflash is allowed.
Examples
Add the new system image file to the SYSTEM environment variable using the boot system command.
switch(config)# boot system system.img
Issue the following command if you are booting from the CompactFlash device (slot 0).
switch(config)# boot system slot0:system.img
The switch updates the SYSTEM environment variable to reflect the new image file in the specified Flash device.
Overwrite the old Kickstart environment variable in the configuration file using the boot kickstart command:
switch(config)# boot kickstart kickstart.img