show ip arp inspection interfaces

To display the trust state for the specified interface, use the show ip arp inspection interfaces command.

show ip arp inspection interfaces { ethernet slot / port | port-channel channel-number }

Syntax Description

ethernet slot / port
(Optional) Specifies that the output is for an Ethernet interface.
port-channel channel-number
(Optional) Specifies that the output is for a port-channel interface. Valid port-channel numbers are from 1 to 4096.

Command Default

None

Command Modes

Any command mode

Command History

Release
Modification
5.0(3)N1(1)
This command was introduced.

Examples

This example shows how to display the trust state for a trusted interface:

switch# show ip arp inspection interfaces ethernet 2/1
 

Related Commands

Command
Description
ip arp inspection vlan
Enables Dynamic ARP Inspection (DAI) for a specified list of VLANs.
show ip arp inspection
Displays the DAI configuration status.
show ip arp inspection vlan
Displays DAI status for a specified list of VLANs.
show running-config dhcp
Displays DHCP snooping configuration, including the DAI configuration.