radius-server deadtime

To configure the dead-time interval for all RADIUS servers on a Cisco Nexus 5000 Series switch, use the radius-server deadtime command. To revert to the default, use the no form of this command.

radius-server deadtime minutes

no radius-server deadtime minutes

Syntax Description

minutes
Number of minutes for the dead-time interval. The range is from 1 to 1440 minutes.

Command Default

0 minutes

Command Modes

Global configuration mode

Command History

Release
Modification
4.0(0)N1(1a)
This command was introduced.

Usage Guidelines

The dead-time interval is the number of minutes before the switch checks a RADIUS server that was previously unresponsive.


Note When the idle time interval is 0 minutes, periodic RADIUS server monitoring is not performed.


Examples

This example shows how to configure the global dead-time interval for all RADIUS servers to perform periodic monitoring:

switch(config)# radius-server deadtime 5
 

This example shows how to revert to the default for the global dead-time interval for all RADIUS servers and disable periodic server monitoring:

switch(config)# no radius-server deadtime 5
 

Related Commands

Command
Description
show radius-server
Displays RADIUS server information.