address-family (RIP)

To configure an address family for the Routing Information Protocol (RIP), use the address-family command in router configuration mode.

address-family ipv4 unicast

Syntax Description

ipv4
Specifies the IPv4 address family.
unicast
Specifies unicast address support.

Command Default

This command has no default settings.

Command Modes

Router configuration mode

Command History

Release
Modification
5.0(3)N1(1)
This command was introduced.

Examples

This example shows how to set the IPv4 unicast address family for a RIP instance:

switch(config)# router rip Enterprise
switch(config-router)# address-family ipv4 unicast
 

Related Commands

Command
Description
default-information
Controls the distribution of a default route.
default-metric
Configures the default metric for routes redistributed into RIP.
distance
Configures the administrative distance.
maximum-paths
Configures the maximum number of equal-cost paths.
redistribute
Configures route redistribution for RIP.
show ip rip
Displays a summary of RIP information for all RIP instances.
timers
Configures the RIP timers.