policy-map type queuing

To create or modify a policy map and enter the policy map type queuing configuration mode, use the policy-map type queuing command. To remove a policy map, use the no form of this command.

policy-map type queuing queuing-policy-map-name

no policy-map type queuing queuing-policy-map-name

Syntax Description

queuing-policy-map-name
Name assigned to a type queuing policy map. The name can be a maximum of 40 alphanumeric characters.

Command Default

None

Command Modes

Global configuration mode

Command History

Release
Modification
4.1(3)N1(1)
This command was introduced.

Usage Guidelines

Use the service-policy command to assign policy maps to interfaces.

On a Cisco Nexus 5548 switch that runs Cisco NX-OS release 5.0(2)N1(1), the switch software does not automatically attach the class-fcoe class map to a policy map. You can manually add the class-fcoe class to a policy map. On all other Cisco Nexus 5000 Series switches, this class is, by default, included in a policy map. On a Cisco Nexus 5548 switch, you can remove the class-fcoe class from a policy map.

You can configure the following on a class-fcoe class map:

Examples

This example shows how to create or modify a queuing policy map:

switch(config)# policy-map type queuing my_policy1
switch(config-pmap-que)# class type queuing my_class1
switch(config-pmap-c-que)# bandwidth percent 75
switch(config-pmap-c-que)# exit
switch(config-pmap-que)#
 

This example shows how to remove a type queuing policy map:

switch(config)# no policy-map type queuing my_policy1
switch(config)#
 

Related Commands

Command
Description
bandwidth
Configures the interface bandwidth.
service-policy
Attaches a policy map to an interface.
set qos-group
Assigns a QoS group identifier for a class of traffic.
show policy-map
Displays policy maps.