show ip mroute summary

To display summary information about IPv4 multicast routes, use the show ip mroute summary command.

show ip mroute summary [ count | software-forwarded ] [ vrf { vrf-name | all }]

show ip mroute [ group ] summary [ software-forwarded ] [ vrf { vrf-name | all }]

Syntax Description

count
(Optional) Displays only route counts.
software-
forwarded
(Optional) Displays software-switched route counts only.
vrf
(Optional) Applies to a virtual routing and forwarding (VRF) instance.
vrf-name
VRF name. The name can be a maximum of 32 alphanumeric characters and is case sensitive.
all
Specifies all VRFs.
group
(Optional) Specifies a group address for a route.

Command Default

None

Command Modes

Any command mode

Command History

Release
Modification
5.0(3)N1(1)
This command was introduced.

Usage Guidelines

This command requires the LAN Base Services license.

Examples

This example shows how to display summary information about IPv4 multicast routes:

switch(config)# show ip mroute summary
IP Multicast Routing Table for VRF "default"
 
Total number of routes: 1
Total number of (*,G) routes: 0
Total number of (S,G) routes: 0
Total number of (*,G-prefix) routes: 1
Group count: 0, rough average sources per group: 0.0
 
Group: 232.0.0.0/8, Source count: 0
Source packets bytes aps pps bit-rate oifs
(*,G) 0 0 0 0 0.000 bps 0
 
switch(config)#
 

This example shows how to display the number of IPv4 multicast routes:

switch# show ip mroute summary count
IP Multicast Routing Table for VRF "default"
 
Total number of routes: 2
Total number of (*,G) routes: 1
Total number of (S,G) routes: 0
Total number of (*,G-prefix) routes: 1
Group count: 1, rough average sources per group: 0.0
switch#
 

Related Commands

Command
Description
show ip mroute
Displays information about IPv4 multicast routes.