ip routing multicast software-replicate

To enable software replication of IPv4 Protocol Independent Multicast (PIM) Any Source Multicast (ASM) packets that are leaked to the software for state creation, use the ip routing multicast software-replicate command. To reset to the default, use the no form of this command.

ip routing multicast software-replicate

no ip routing multicast software-replicate

Syntax Description

This command has no arguments or keywords.

Command Default

No software replication.

Command Modes

Global configuration mode

Command History

Release
Modification
5.0(3)N1(1)
This command was introduced.

Usage Guidelines

By default, these packets are used by the software only for (S,G) state creation and then dropped.

This command does not require a license.

Examples

This example shows how to enable software replication of IPv4 PIM ASM packets:

switch(config)# ip routing multicast software-replicate
switch(config)#

Related Commands

Command
Description
show running-config
Displays information about the running-system configuration.