ip pim neighbor-policy

To configure a route-map policy that determines which IPv4 Protocol Independent Multicast (PIM) neighbors should become adjacent, use the ip pim neighbor-policy command. To reset to the default, use the no form of this command.

ip pim neighbor-policy policy-name

no ip pim neighbor-policy [ policy-name ]

Syntax Description

policy-name
Route-map policy name.

Command Default

Forms adjacency with all neighbors.

Command Modes

Interface configuration mode

Command History

Release
Modification
5.0(3)N1(1)
This command was introduced.

Usage Guidelines

You can use the match ip address command in a route-map policy to specify which groups to become adjacent to.

This command requires the LAN Base Services license.

Examples

This example shows how to configure a policy that determines which PIM neighbors should become adjacent:

switch(config)# interface ethernet 2/2
switch(config-if)# ip pim neighbor-policy
 

This example shows how to reset to the default:

switch(config)# interface ethernet 2/2
switch(config-if)# no ip pim neighbor-policy
 

Related Commands

Command
Description
show ip pim interface
Displays information about PIM-enabled interfaces.