ip pim dr-priority

To configure the designated router (DR) priority that is advertised in IPv4 Protocol Independent Multicast (PIM) hello messages, use the ip pim dr-priority command. To reset the DR priority to the default, use the no form of this command.

ip pim dr-priority priority

no ip pim dr-priority [ priority ]

Syntax Description

priority
Priority value. The range is from 1 to 4294967295. The default is 1.

Command Default

The DR priority is 1.

Command Modes

Interface configuration mode

Command History

Release
Modification
5.0(3)N1(1)
This command was introduced.

Usage Guidelines

This command requires the LAN Base Services license.

Examples

This example shows how to configure DR priority on an interface:

switch(config)# interface ethernet 2/2
switch(config-if)# ip pim dr-priority 5
 

This example shows how to reset DR priority on an interface to the default:

switch(config)# interface ethernet 2/2
switch(config-if)# no ip pim dr-priority
 

Related Commands

Command
Description
show ip pim interface
Displays information about PIM-enabled interfaces.