show interface transceiver

To display the information about the transceivers connected to a specific interface, use the show interface transceiver command.

show interface ethernet slot / port transceiver [ details ]

Syntax Description

ethernet slot / port
Displays information about an Ethernet interface slot number and port number. The slot number is from 1 to 255, and the port number is from 1 to 128.
details
(Optional) Displays detailed information about the transceivers on an interface.

Command Default

None

Command Modes

EXEC mode

Command History

Release
Modification
4.0(0)N1(1a)
This command was introduced.

Usage Guidelines

You can use the show interface transceiver command only for physical interfaces.

Examples

This example shows how to display the transceivers connected to a specified Ethernet interface:

switch# show interface ethernet 1/1 transceiver
Ethernet1/1
transceiver is present
type is SFP-H10GB-CU1M
name is CISCO-MOLEX
part number is 74752-9044
revision is 07
serial number is MOC14081360
nominal bitrate is 10300 MBit/sec
Link length supported for copper is 1 m
cisco id is --
cisco extended id number is 4
 
switch#
 

Related Commands

Command
Description
interface ethernet
Configures an Ethernet IEEE 802.3 interface.
show interface capabilities
Displays detailed information about the capabilities of an interface.