lacp suspend-individual

To enable Link Aggregation Control Protocol (LACP) port suspension on a port channel, use the lacp suspend-individual command. To disable port suspension on a port channel interface, use the no form of this command.

lacp suspend-individual

no lacp suspend-individual

Syntax Description

This command has no arguments or keywords.

Command Default

Disabled

Command Modes

Interface configuration mode

Command History

Release
Modification
5.0(2)N1(1)
This command was introduced.

Usage Guidelines

LACP sets a port to the suspended state if it does not receive an LACP bridge protocol data unit (BPDU) from the peer ports in a port channel. This can cause some servers to fail to boot up as they require LACP to logically bring up the port.

This command does not require a license.

Examples

This example shows how to enable LACP port suspension on a port channel:

switch# configure terminal
switch(config)# interface port-channel 100
switch(config-if)# shutdown
switch(config-if)# lacp suspend-individual
switch(config-if)#
 

This example shows how to disable LACP port suspension on a port channel:

switch# configure terminal
switch(config)# interface port-channel 100
switch(config-if)# no lacp suspend-individual
switch(config-if)#

Related Commands

Command
Description
show lacp
Displays LACP information.
show running-config
Displays the running system configuration.