feature lacp

To enable the Link Aggregation Control Protocol (LACP), which bundles a number of physical ports together to form a single logical channel, use the feature lacp command. To disable LACP on the switch, use the no form of this command.

feature lacp

no feature lacp

Syntax Description

This command has no arguments or keywords.

Command Default

LACP is disabled.

Command Modes

Global configuration mode

Command History

Release
Modification
4.0(0)N1(1a)
This command was introduced.

Usage Guidelines

You must remove all the LACP configuration parameters from all EtherChannels on the switch before you can disable LACP.

Even after you enable LACP globally, you do not have to run LACP on all EtherChannels on the switch. You enable LACP on each channel mode using the channel-group mode command.

Examples

This example shows how to enable LACP EtherChannels on the switch:

switch(config)# feature lacp
 

Related Commands

Command
Description
show lacp
Displays information on LACP.
show feature
Displays whether or not LACP is enabled on the switch.