destination (ERSPAN)

To configure an Encapsulated Remote Switched Port Analyzer (ERSPAN) destination IP address, use the destination command. To remove the destination ERSPAN IP address, use the no form of this command.

destination ip ip_address

no destination ip ip_address

Syntax Description

ip
Configures the remote IP address.
ip_address
IPv4 address in the format A . B . C . D .

Command Default

None

Command Modes

ERSPAN session configuration mode

Command History

Release
Modification
5.1(3)N1(1)
This command was introduced.

Usage Guidelines

You can configure only one destination IP address for an ERSPAN source session.

This command does not require a license.

Examples

This example shows how to configure an ERSPAN destination IP address:

switch# configure terminal
switch(config)# monitor session 1 type erspan-source
switch(config-erspan-src)# destination ip 192.0.3.1
switch(config-erspan-src)#
 

Related Commands

Command
Description
monitor session
Creates a new SPAN session configuration.
show monitor session
Displays SPAN session configuration information.
show running-config monitor
Displays the running configuration information of a SPAN session.
source (SPAN session)
Configures a source SPAN port.
source (ERSPAN session)
Configures a source VLAN or VSAN interface.