show ip igmp route

To display information about the IGMP-attached group membership, use the show ip igmp route command.

show ip igmp route [{ source [ group ]} | { group [ source ]}] [ ethernet slot / port | port-channel channel-number [ . sub_if_number ] | vlan vlan-id ] [ vrf { vrf-name | all }]

Syntax Description

source
Source IP address.
group
(Optional) Multicast IP address of single group to display.
ethernet slot / port
Specifies the Ethernet interface and the slot number and port number. The slot number is from 1 to 255, and the port number is from 1 to 128.
port-channel number
Specifies the EtherChannel interface and EtherChannel number. The range is from 1 to 4096.
sub_if_number
Subinterface number. The range is from 1 to 4093.
vlan vlan-id
Specifies the VLAN. The range is from 1 to 4094.
vrf
(Optional) Applies to a virtual routing and forwarding (VRF) instance.
vrf-name
VRF name. The name can be a maximum of 32 alphanumeric characters and is case sensitive.
all
Specifies all VRFs.

Command Default

None

Command Modes

Any command mode

Command History

Release
Modification
5.0(3)N1(1)
This command was introduced.

Usage Guidelines

The show ip igmp groups command is an alternative form of this command.

This command does not require a license.

Examples

This example shows how to display information about the IGMP-attached group membership:

switch# show ip igmp route
IGMP Connected Group Membership for VRF "default" - 1 total entries
Type: S - Static, D - Dynamic, L - Local, T - SSM Translated
Group Address Type Interface Uptime Expires Last Reporter
230.0.0.0 S Ethernet1/5 00:31:47 never 0.0.0.0
switch#
 

Related Commands

Command
Description
show ip igmp groups
Displays information about the IGMP-attached group membership.