ip igmp querier-timeout

To configure a querier timeout that the software uses when deciding to take over as the querier, use the ip igmp querier-timeout command. To reset to the querier timeout to the default, use the no form of this command.

ip igmp querier-timeout timeout

no ip igmp querier-timeout [ timeout ]

Syntax Description

timeout
Timeout in seconds. The range is from 1 to 65,535. The default is 255.

Command Default

The querier timeout is 255 seconds.

Command Modes

Interface configuration mode

Command History

Release
Modification
5.0(3)N1(1)
This command was introduced.

Usage Guidelines

The ip igmp query-timeout command is an alternative form of this command.

This command does not require a license.

Examples

This example shows how to configure a querier timeout:

switch(config)# interface ethernet 2/2
switch(config-if)# ip igmp querier-timeout 200
switch(config-if)#
 

This example shows how to reset a querier timeout to the default:

switch(config)# interface ethernet 2/2
switch(config-if)# no ip igmp querier-timeout
switch(config-if)#
 

Related Commands

Command
Description
ip igmp query-timeout
Configures a querier timeout.
show ip igmp interface
Displays IGMP information about the interface.