fabricpath isis hello-multiplier

To set an Intermediate System-to-Intermediate System (IS-IS) multiplier for a hello holding time per interface, use the fabricpath isis hello-multiplier command. To return to the default setting, use the no form of this command.

fabricpath isis hello-multiplier multiplier

no fabricpath isis hello-multiplier multiplier

Syntax Description

multiplier
Hello interval value. The range is from 3 to 1000.

Command Default

The default value is 3.

Command Modes

Interface configuration mode

Command History

Release
Modification
5.1(3)N1(1)
This command was introduced.

Usage Guidelines


Note A level specification is not required.


This command requires an Enhanced Layer 2 license.

Examples

This example shows how to set a hello interval in seconds:

switch# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
switch(config)# interface ethernet 5/5
switch(config-if)# fabricpath isis hello-multiplier 20
switch(config-if)#
 

Related Commands

Command
Description
show fabricpath isis
Displays FabricPath IS-IS information.