show interface vfc

To display the configuration information of virtual Fibre Channel interfaces, use the show interface vfc command.

show interface vfc vfc-id [ brief ] [ counters ]

Syntax Description

vfc-id
Virtual Fibre Channel interface ID. The range is from 1 to 8192.
brief
(Optional) Displays brief information about the virtual Fibre Channel interfaces.
counters
(Optional) Displays the virtual Fibre Channel interface counters.

Command Default

None

Command Modes

EXEC mode

Command History

Release
Modification
4.0(0)N1(1a)
This command was introduced.

Examples

This example shows how to display the configuration information for a specified virtual Fibre Channel interface:

switch# show interface vfc 1
vfc1 is down (Administratively down)
Bound MAC is 00:50:3e:8d:64:00
Hardware is Virtual Fibre Channel
Port WWN is 20:00:00:05:9b:23:40:7f
Admin port mode is F, trunk mode is on
snmp link state traps are enabled
Port vsan is 1
1 minute input rate 0 bits/sec, 0 bytes/sec, 0 frames/sec
1 minute output rate 0 bits/sec, 0 bytes/sec, 0 frames/sec
0 frames input, 0 bytes
0 discards, 0 errors
0 frames output, 0 bytes
0 discards, 0 errors
last clearing of "show interface" counters never
 
switch#
 

This example shows how to display a brief information for a specified virtual Fibre Channel interface:

switch# show interface vfc 5 brief
 
-------------------------------------------------------------------------------
Interface Vsan Admin Admin Status SFP Oper Oper Port
Mode Trunk Mode Speed Channel
Mode (Gbps)
-------------------------------------------------------------------------------
vfc5 1 E on down -- -- --
switch#
 

This example shows how to display the counters for a specified virtual Fibre Channel interface:

switch# show interface vfc 5 counters
vfc5
5 minute input rate 0 bits/sec, 0 bytes/sec, 0 frames/sec
5 minute output rate 0 bits/sec, 0 bytes/sec, 0 frames/sec
0 frames input, 0 bytes
0 discards, 0 errors, 0 CRC
0 too long, 0 too short
0 frames output, 0 bytes
0 discards, 0 errors
0 input OLS, 0 LRR, 0 NOS, 0 loop inits
0 output OLS, 0 LRR, 0 NOS, 0 loop inits
0 link failures, 0 sync losses, 0 signal losses
0 BB credit transitions from zero
 
switch#
 

Related Commands

Command
Description
interface vfc
Configures a virtual Fibre Channel interface.