show fcoe-npv issu-impact

To display the configuration issues caused by the Fibre Channel over Ethernet (FCoE) N-Port Virtualizer (NPV) during a nondisruptive in-service software upgrade (ISSU), use the show fcoe-npv issu-impact command.

show fcoe-npv issu-impact

Syntax Description

This command has no arguments or keywords.

Command Default

None

Command Modes

EXEC mode

Command History

Release
Modification
5.0(3)N2(1)
This command was introduced.

Usage Guidelines

Before you use this command, make sure that you enable Fibre Channel over Ethernet (FCoE) N-Port Virtualizer (NPV) on the switch by using the feature fcoe-npv command.

This command requires the FCoE NPV license.

Examples

This example shows how to display the configuration issues caused by the FCoE NPV feature:

switch# show fcoe-npv issu-impact
show fcoe-npv issu-impact
-------------------------
 
Please make sure to enable "disable-fka" on all logged in VFCs
Please increase the FKA duration to 60 seconds on FCF
 
 
Active VNP ports with no disable-fka set
----------------------------------------
 
 
ISSU downgrade not supported as feature fcoe-npv is enabled
switch#
 

Related Commands

Command
Description
feature fcoe-npv
Enables FCoE NPV on the switch.
show running-config fcoe_mgr
Displays the FCoE running configuration information.
show tech-support fcoe
Displays troubleshooting information about FCoE.