interface san-port-channel

To configure a SAN port channel interface on a Cisco Nexus 5000 Series switch, use the interface san-port-channel command. To revert to the defaults, use the no form of this command.

interface san-port-channel port

no interface san-port-channel port

Syntax Description

port
SAN port channel interface ID. The range is from 1 to 256.

Command Default

None

Command Modes

Global configuration mode

Command History

Release
Modification
4.0(0)N1(1a)
This command was introduced.
5.1(3)N1(1)
The description , shutdown , and switchport keywords were separated from the interface san-port-channel command. They are documented as separate commands.

Usage Guidelines

This command does not require a license.

Examples

This example shows how to configure SAN port channel interface 3:

switch# configure terminal
switch(config)# interface san-port-channel 3
switch(config-if)#
 

Related Commands

Command
Description
channel mode active (SAN PortChannel)
Configures a SAN port channel interface as an active port channel port.
show interface
Displays an interface configuration for a specified interface.
shutdown
Disables and enables an interface.
switchport (SAN PortChannel)
Configures switch port parameters on a SAN port channel interface.