zone default-zone

To define whether a default zone (assigned to nodes not assigned to a created zone) permits or denies access to all nodes in the default zone, use the zone default-zone command. To negate the command or revert to the factory defaults, use the no form of this command.

zone default-zone permit vsan vsan-id

no zone default-zone permit vsan vsan-id

Syntax Description

permit

Permits access to all nodes in the default zone.

vsan vsan-id

Sets default zoning behavior for the specified Virtual SAN (VSAN). The ID of the VSAN is from 1 to 4093.


Command Default

All default zones are permitted access.

Command Modes

Global configuration mode

Command History

Release
Modification

4.0(0)N1(1a)

This command was introduced.


Usage Guidelines

Use the zone default-zone permit vsan command to define the operational values for the default zone in a VSAN. This command applies to existing VSANs; it has no effect on VSANs that have not yet been created.

Use the system default zone default-zone permit command to use the default values defined for the default zone for all VSANs. The default values are used when you initially create a VSAN and it becomes active.

Examples

This example shows how to permit the default zoning in VSAN 2:

switch(config)# zone default-zone permit vsan 2 

Related Commands

Command
Description

system default zone default-zone permit

Configures default values for a zone.

show zone

Displays zone information.