show routing multicast

To display information about IPv4 multicast routes, use the show routing multicast command.

show routing [ip | ipv4] multicast [vrf {vrf-name | all | default | management}] {{source group} | {group [source]}}

Syntax Description

ip

(Optional) Specifies IPv4 routes.

ipv4

(Optional) Specifies IPv4 routes.

vrf

(Optional) Applies to a virtual routing and forwarding (VRF) instance.

vrf-name

VRF name. The name can be a maximum of 32 alphanumeric characters and is case sensitive.

all

Specifies all VRFs.

default

Specifies the default VRF.

management

Specifies the management VRF.

source

Source address for routes.

group

Group address for routes.


Command Default

None

Command Modes

Any command mode

Command History

Release
Modification

5.0(3)N1(1)

This command was introduced.


Usage Guidelines

This command requires the LAN Base Services license.

Examples

This example shows how to display information about IPv4 multicast routes:

switch(config)# show routing multicast
IP Multicast Routing Table for VRF "default"

(*, 232.0.0.0/8), uptime: 05:11:19, pim ip
  Incoming interface: Null, RPF nbr: 0.0.0.0
  Outgoing interface list: (count: 0)

switch(config)#