show ip igmp route

To display information about the IGMP-attached group membership, use the show ip igmp route command.

show ip igmp route [{source [group]} | {group [source]}] [ethernet slot/port | port-channel channel-number[.sub_if-number] | vlan vlan-id] [vrf {vrf-name | all}]

Syntax Description

source

Source IP address.

group

(Optional) Multicast IP address of single group to display.

ethernet slot/port

(Optional) Specifies the Ethernet interface and the slot number and port number. The slot number is from 1 to 255, and the port number is from 1 to 128.

port-channel number

(Optional) Specifies the EtherChannel interface and EtherChannel number. The range is from 1 to 4096.

sub_if-number

(Optional) Subinterface number. The range is from 1 to 4093.

vlan vlan-id

(Optional) Specifies the VLAN. The range is from 1 to 4094.

vrf

(Optional) Applies to a virtual routing and forwarding (VRF) instance.

vrf-name

VRF name. The name can be a maximum of 32 alphanumeric characters and is case sensitive.

all

Specifies all VRFs.


Command Default

None

Command Modes

Any command mode

Command History

Release
Modification

5.0(3)N1(1)

This command was introduced.


Usage Guidelines

The show ip igmp groups command is an alternative form of this command.

Examples

This example shows how to display information about the IGMP-attached group membership:

switch# show ip igmp route
IGMP Connected Group Membership for VRF "default" - 1 total entries
Type: S - Static, D - Dynamic, L - Local, T - SSM Translated
Group Address      Type Interface           Uptime    Expires   Last Reporter
230.0.0.0          S    Ethernet1/5         00:31:47  never     0.0.0.0
switch#

Related Commands

Command
Description

show ip igmp groups

Displays information about the IGMP-attached group membership.