lldp (interface)

To enable the reception, or transmission, of Link Layer Discovery Protocol (LLDP) packets on an interface, use the lldp command. To disable the reception or transmission of LLDP packets, use the no form of this command.

lldp {receive | transmit}

no lldp {receive | transmit}

Syntax Description

receive

Specifies that the interface receive LLDP packets.

transmit

Specifies that the interface transmit LLDP packets.


Command Default

None

Command Modes

Interface configuration mode

Command History

Release
Modification

4.0(0)N1(1a)

This command was introduced.


Examples

This example shows how to set an interface to transmit LLDP packets:

switch(config)# interface ethernet 2/1 
switch(config-if)# lldp transmit 
switch(config-if)# 

Related Commands

Command
Description

show interface

Displays configuration information about interfaces.