ip msdp sa-limit

To configure a limit on the number of (S, G) entries accepted from the peer, use the ip msdp sa-limit command. To remove the limit, use the no form of this command.

ip msdp sa-limit peer-address limit

no ip msdp sa-limit peer-address [limit]

Syntax Description

peer-address

IP address of an MSDP peer.

limit

Number of (S, G) entries. The range is from 0 to 4294967295. The default is none.


Command Default

None

Command Modes

Global configuration mode

Command History

Release
Modification

5.0(3)N1(1)

This command was introduced.


Usage Guidelines

This command requires the LAN Base Services license.

Examples

This example shows how to configure a Source-Active (SA) limit for a peer:

switch(config)# ip msdp sa-limit 192.168.1.10 5000

This example shows how to reset the limit to the default:

switch(config)# no ip msdp sa-limit 192.168.1.10

Related Commands

Command
Description

show ip msdp peer

Displays information about MSDP peers.