ip igmp ssm-translate

To translate IGMPv1 or IGMPv2 membership reports to create the (S, G) state so that the router treats them as IGMPv3 membership reports, use the ip igmp ssm-translate command. To remove the translation, use the no form of this command.

ip igmp ssm-translate group source

no ip igmp ssm-translate group source

Syntax Description

group

IPv4 multicast group range. By default, the group prefix range is 232.0.0.0/8. To modify the IPv4 Protocol Independent Multicast (PIM) SSM range, see the ip pim ssm range command.

source

IP multicast address source.


Command Default

None

Command Modes

Global configuration mode

VRF configuration mode

Command History

Release
Modification

5.0(3)N1(1)

This command was introduced.


Usage Guidelines

To display SSM translation commands, use this command line:

switch(config)# show running-config | include ssm-translation

This command does not require a license.

Examples

This example shows how to configure a translation:

switch(config)# ip igmp ssm-translate 232.0.0.0/8 10.1.1.1

This example shows how to remove a translation:

switch(config)# no ip igmp ssm-translate 232.0.0.0/8 10.1.1.1

Related Commands

Command
Description

show running-config

Displays information about the running-system configuration.