ip igmp last-member-query-count

To configure the number of times that the software sends an IGMP query in response to a host leave message, use the ip igmp last-member-query-count command. To reset the query interval to the default, use the no form of this command.

ip igmp last-member-query-count count

no ip igmp last-member-query-count [count]

Syntax Description

count

Query count. The range is from 1 to 5. The default is 2.


Command Default

The query count is 2.

Command Modes

Interface configuration mode

Command History

Release
Modification

5.0(3)N1(1)

This command was introduced.


Usage Guidelines

This command does not require a license.

Examples

This example shows how to configure a query count:

switch(config)# interface ethernet 2/2
switch(config-if)# ip igmp last-member-query-count 3
switch(config-if)# 

This example shows how to reset a query count to the default:

switch(config)# interface ethernet 2/2
switch(config-if)# no ip igmp last-member-query-count
switch(config-if)# 

Related Commands

Command
Description

show ip igmp interface

Displays IGMP information about the interface.