Utilizzo dei loopback per il test delle interfacce Ethernet
Se necessario, i loopback possono essere utilizzati per individuare problemi relativi a schede di linea, fabric, processori di rete (NP), ricetrasmettitori o percorsi di transito ottici.
Esistono due tipi principali di loopback: interno ed esterno.
I loop interni possono essere eseguiti in remoto, ma non forniscono la stessa quantità di informazioni.
I loop esterni devono essere eseguiti nel sito, ma forniscono la quantità maggiore di informazioni.
Gli esempi che seguono utilizzano questa interfaccia:
RP/0/RSP0/CPU0:ASR9001-F# show run int tenGigE 0/0/1/1 interface TenGigE0/0/1/1 ipv4 address 10.100.101.1 255.255.255.0 !
Loopback interno
Si tratta di un test di base che può essere eseguito senza accedere a un sito remoto. È in grado di rilevare problemi relativi alla CPU, al percorso della struttura, alla rete NP e al ricetrasmettitore, ma non è in grado di rilevare problemi ottici o di transito.
Configurazione del loopback
Questo ha un impatto sul traffico
RP/0/RSP0/CPU0:ASR9001-F# configure RP/0/RSP0/CPU0:ASR9001-F(config)# int tenGigE 0/0/1/1 RP/0/RSP0/CPU0:ASR9001-F(config-if)# loopback internal RP/0/RSP0/CPU0:ASR9001-F(config-if)# commit RP/0/RSP0/CPU0:ASR9001-F(config-if)# end
clear counters
I contatori sull'interfaccia e sul controller vengono cancellati.
RP/0/RSP0/CPU0:ASR9001-F# clear counters tenGigE 0/0/1/1 Clear "show interface" counters on this interface [confirm]
Eseguire il ping dell'IP locale
RP/0/RSP0/CPU0:ASR9001-F# ping 10.100.101.1 count 10000 size 1500 timeout 0 pings with timeout=0 may result in system instability and control protocol flaps resulting in traffic impact. DO you really want to continue[confirm with only 'y' or 'n'] [y/n] :y Type escape sequence to abort. Sending 10000, 1500-byte ICMP Echos to 10.100.101.1, timeout is 0 seconds: !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!! [output omitted] !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!! Success rate is 100 percent (10000/10000), round-trip min/avg/max = 1/1/5 ms
Controlla contatori interfaccia
RP/0/RSP0/CPU0:ASR9001-F# show interfaces tenGigE 0/0/1/1
TenGigE0/0/1/1 is up, line protocol is up
Interface state transitions: 3
Hardware is TenGigE, address is 70e4.2217.ba65 (bia 70e4.2217.ba65)
Layer 1 Transport Mode is LAN
Internet address is 10.100.101.1/24
MTU 1514 bytes, BW 10000000 Kbit (Max: 10000000 Kbit)
reliability 255/255, txload 0/255, rxload 0/255
Encapsulation ARPA,
Full-duplex, 10000Mb/s, link type is force-up
output flow control is off, input flow control is off
loopback set (External),
ARP type ARPA, ARP timeout 04:00:00
Last input 00:00:00, output 00:00:00
Last clearing of "show interface" counters 00:02:40
5 minute input rate 685000 bits/sec, 126 packets/sec
5 minute output rate 685000 bits/sec, 126 packets/sec
10003 packets input, 15140657 bytes, 0 total input drops
0 drops for unrecognized upper-level protocol
Received 0 broadcast packets, 3 multicast packets
0 runts, 0 giants, 0 throttles, 0 parity
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
10003 packets output, 15140657 bytes, 0 total output drops
Output 0 broadcast packets, 3 multicast packets
0 output errors, 0 underruns, 0 applique, 0 resets
0 output buffer failures, 0 output buffers swapped out
0 carrier transitions
Controllare i contatori dei controller
RP/0/RSP0/CPU0:ASR9001-F# show controllers tenGigE 0/0/1/1 stats
Statistics for interface TenGigE0/0/1/1 (cached values):
Ingress:
Input total bytes = 15140657
Input good bytes = 15140657
Input total packets = 10003
Input 802.1Q frames = 0
Input pause frames = 0
Input pkts 64 bytes = 0
Input pkts 65-127 bytes = 0
Input pkts 128-255 bytes = 3
Input pkts 256-511 bytes = 0
Input pkts 512-1023 bytes = 0
Input pkts 1024-1518 bytes = 10000
Input pkts 1519-Max bytes = 0
Input good pkts = 10003
Input unicast pkts = 10000
Input multicast pkts = 3
Input broadcast pkts = 0
Input drop overrun = 0
Input drop abort = 0
Input drop invalid VLAN = 0
Input drop invalid DMAC = 0
Input drop invalid encap = 0
Input drop other = 0
Input error giant = 0
Input error runt = 0
Input error jabbers = 0
Input error fragments = 0
Input error CRC = 0
Input error collisions = 0
Input error symbol = 0
Input error other = 0
Input MIB giant = 0
Input MIB jabber = 0
Input MIB CRC = 0
Egress:
Output total bytes = 15140657
Output good bytes = 15140657
Output total packets = 10003
Output 802.1Q frames = 0
Output pause frames = 0
Output pkts 64 bytes = 0
Output pkts 65-127 bytes = 0
Output pkts 128-255 bytes = 3
Output pkts 256-511 bytes = 0
Output pkts 512-1023 bytes = 0
Output pkts 1024-1518 bytes = 10000
Output pkts 1519-Max bytes = 0
Output good pkts = 10003
Output unicast pkts = 10000
Output multicast pkts = 3
Output broadcast pkts = 0
Output drop underrun = 0
Output drop abort = 0
Output drop other = 0
Output error other = 0
Loopback esterno
Questo test verifica la CPU (Central Processing Unit) della linecard, il percorso della struttura, l'NP, il ricetrasmettitore e le ottiche.
Questa prova richiede una lunghezza di cavo in fibra per l'anello fisico dei segnali di trasmissione (Tx) nella porta di ricezione (Rx).
Configurazione del loopback
Questo ha un impatto sul traffico
RP/0/RSP0/CPU0:ASR9001-F# configure RP/0/RSP0/CPU0:ASR9001-F(config)# interface tenGigE 0/0/1/1 RP/0/RSP0/CPU0:ASR9001-F(config-if)# loopback external RP/0/RSP0/CPU0:ASR9001-F(config-if)# commit RP/0/RSP0/CPU0:ASR9001-F(config-if)# end
clear counters
I contatori sull'interfaccia e sul controller vengono cancellati.
RP/0/RSP0/CPU0:ASR9001-F# clear counters Clear "show interface" counters on all interfaces [confirm]
Eseguire il ping dell'IP locale
RP/0/RSP0/CPU0:ASR9001-F# ping 10.100.101.1 count 10000 size 1500 timeout 0 pings with timeout=0 may result in system instability and control protocol flaps resulting in traffic impact. DO you really want to continue[confirm with only 'y' or 'n'] [y/n] :y Type escape sequence to abort. Sending 10000, 1500-byte ICMP Echos to 10.100.101.1, timeout is 0 seconds: !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!! [output omitted] !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!! !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!! Success rate is 100 percent (10000/10000), round-trip min/avg/max = 1/1/5 ms
Controlla contatori interfaccia
RP/0/RSP0/CPU0:ASR9001-F# show interfaces tenGigE 0/0/1/1
TenGigE0/0/1/1 is up, line protocol is up
Interface state transitions: 7
Hardware is TenGigE, address is 70e4.2217.ba65 (bia 70e4.2217.ba65)
Layer 1 Transport Mode is LAN
Internet address is 10.100.101.1/24
MTU 1514 bytes, BW 10000000 Kbit (Max: 10000000 Kbit)
reliability 255/255, txload 0/255, rxload 0/255
Encapsulation ARPA,
Full-duplex, 10000Mb/s, link type is force-up
output flow control is off, input flow control is off
loopback set (Internal),
ARP type ARPA, ARP timeout 04:00:00
Last input 00:00:00, output 00:00:00
Last clearing of "show interface" counters 00:00:32
5 minute input rate 504000 bits/sec, 52 packets/sec
5 minute output rate 504000 bits/sec, 52 packets/sec
10001 packets input, 15140219 bytes, 0 total input drops
0 drops for unrecognized upper-level protocol
Received 0 broadcast packets, 1 multicast packets
0 runts, 0 giants, 0 throttles, 0 parity
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
10001 packets output, 15140219 bytes, 0 total output drops
Output 0 broadcast packets, 1 multicast packets
0 output errors, 0 underruns, 0 applique, 0 resets
0 output buffer failures, 0 output buffers swapped out
0 carrier transitions
Controlla contatori controller
RP/0/RSP0/CPU0:ASR9001-F# show controllers tenGigE 0/0/1/1 stats
Statistics for interface TenGigE0/0/1/1 (cached values):
Ingress:
Input total bytes = 15140219
Input good bytes = 15140219
Input total packets = 10001
Input 802.1Q frames = 0
Input pause frames = 0
Input pkts 64 bytes = 0
Input pkts 65-127 bytes = 0
Input pkts 128-255 bytes = 1
Input pkts 256-511 bytes = 0
Input pkts 512-1023 bytes = 0
Input pkts 1024-1518 bytes = 10000
Input pkts 1519-Max bytes = 0
Input good pkts = 10001
Input unicast pkts = 10000
Input multicast pkts = 1
Input broadcast pkts = 0
Input drop overrun = 0
Input drop abort = 0
Input drop invalid VLAN = 0
Input drop invalid DMAC = 0
Input drop invalid encap = 0
Input drop other = 0
Input error giant = 0
Input error runt = 0
Input error jabbers = 0
Input error fragments = 0
Input error CRC = 0
Input error collisions = 0
Input error symbol = 0
Input error other = 0
Input MIB giant = 0
Input MIB jabber = 0
Input MIB CRC = 0
Egress:
Output total bytes = 15140219
Output good bytes = 15140219
Output total packets = 10001
Output 802.1Q frames = 0
Output pause frames = 0
Output pkts 64 bytes = 0
Output pkts 65-127 bytes = 0
Output pkts 128-255 bytes = 1
Output pkts 256-511 bytes = 0
Output pkts 512-1023 bytes = 0
Output pkts 1024-1518 bytes = 10000
Output pkts 1519-Max bytes = 0
Output good pkts = 10001
Output unicast pkts = 10000
Output multicast pkts = 1
Output broadcast pkts = 0
Output drop underrun = 0
Output drop abort = 0
Output drop other = 0
Output error other = 0
Feedback