Cisco Catalyst IW9167E Heavy Duty Access Point Configuration Guide, Release 26.1.x

Configure AP to boot with different image options

Updated: April 10, 2026

Want to summarize with AI?

Configures an AP to boot up in CAPWAP, URWB, or WGB/uWGB mode.

This procedure describes how to configure the access point to boot up with CAPWAP, URWB, or WGB/uWGB mode.

Note

Switching between different modes causes a full factory reset. All configurations and data are removed.

Procedure

	1.	Use the enable command to enter the privileged EXEC mode. Example: `Device# enable` Enter your password if prompted.
	2.	Use the configure boot mode { capwap \| urwb \| wgb } command to configure AP to CAPWAP, URWB, or WGB/uWGB mode. Example: `Device# configure boot mode wgb` The AP reboots with the specified mode.

Need help?

Open a support case

(Requires a Cisco Service Contract)

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.

Configure AP to boot with different image options

Procedure

Example:

Example: