Cisco Catalyst IW9167E Heavy Duty Access Point Configuration Guide, Release 26.1.x

Configure indoor deployment for -E domain using CLI

Updated: April 10, 2026

Want to summarize with AI?

Configures the AP for indoor deployment mode using the wireless controller.

This procedure describes how to configure the access point for indoor deployment mode using the wireless LAN controller.

Procedure

	1.	Use the ap nameap-nameindoor command from the wireless controller to configure the access point for indoor mode. Example: `Device# ap name APFC58.9A15.C9A4 indoor` This command triggers an access point reboot. After the access point reboots and re-registers with the wireless LAN controller, assign the appropriate country code to the access point. The 5-GHz radio supports these channels: 36, 40, 44, 48, 52, 56, 60, 64, 100, 104, 108, 112, 116, 120, 124, 128, 132, 136, and 140. Note The channel list includes U-NII-2c, U-NII-1, and U-NII-2a frequency bands (except channel 144).
	2.	Use the ap nameap-nameno indoor command from the wireless controller to disable indoor deployment. Example: `Device# ap name APFC58.9A15.C9A4 no indoor`

Need help?

Open a support case

(Requires a Cisco Service Contract)

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.

Configure indoor deployment for -E domain using CLI

Procedure

Example:

Example: