Guides AP mode features such as indoor deployment, 802.11ax guard interval settings, RAP Ethernet daisy chaining, Ethernet bridging, WSTP verification, and GNSS control.
Indoor deployment for -E domain
Indoor deployment for -E domain
Configure indoor deployment for -E domain using CLI
Configures the AP for indoor deployment mode using the wireless controller.
Configure indoor deployment for -E domain using GUI
Configures the AP for indoor deployment mode using the wireless controller.
802.11ax 1600ns and 3200ns guard interval support
802.11ax 1600ns and 3200ns Guard Interval Support
RAP Ethernet Daisy Chain
Enhances the existing Ethernet bridging functionality by forcing the bridge access point to use the Ethernet link as the uplink backhaul.
GNSS
Introduces GNSS enhancements in Release 26.1.1, including controller-based enable or disable support and improved runtime status and diagnostic output.
Disable GNSS
Explains how to dynamically disable GNSS on a specific access point to prevent inaccurate location reporting when satellite signals are weak.
Enable GNSS
Guides how to re-enable GNSS service on a specific access point from the controller using the appropriate geolocation command.
Check the status of the GNSS module
Describes how to verify the administrative state of the GNSS module on an access point using the show gnss info command.
GNSS status and diagnostics
Explains the enhanced GNSS diagnostic output, including satellite details, signal quality, location data, fix status, accuracy, and uncertainty information.