Cisco Catalyst IW9167E Heavy Duty Access Point Configuration Guide, Release 26.1.x

Assign the Country Code to a WGB or uWGB with -ROW PID

Updated: April 10, 2026

Want to summarize with AI?

Learn how to assign the proper country code to a WGB or uWGB device with a -ROW PID so that the device loads the correct power table after rebooting.

This procedure describes how to assign the proper country code to a WGB or uWGB device with a -ROW PID.

On day 0, you should assign the proper country code to the WGB/uWGB with -ROW regulatory domain. The WGB will load the corresponding power table after rebooting.

Procedure

Use the configure countrycode country-code command to configure the country code to a WGB or uWGB device with a -ROW PID.

Example:

Device# configure countrycode IN

Note

After you configure the ROW country code, perform a factory reset before you change the configuration to another country. Then, configure the new country code.

Need help?

Open a support case

(Requires a Cisco Service Contract)

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.