number of clients (connected and detected) that can be displayed at a given
time is 2000. If this limit is exceeded, only connected clients are displayed,
again up to a maximum of 2000 (see the figure below). However, if the number of
total connected clients also exceeds 2000, no clients are displayed. In such a
scenario, we recommend that you use the Analytics service to view the client
icon to show or hide areas with varying concentrations of client devices. Areas
with a high concentration of client devices are marked bright red, as shown in
icon to show or hide the zones on a specific floor.
icon to show or hide all the APs that have been deployed on a specific floor.
APs are displayed as circular objects, with a number in the center. This number
indicates the number of clients connected to that specific AP.
In Cisco CMX Release 10.2.1, when you select an
access point icon from a floor map displayed on the
Activity Map window, the
Access Point information area includes Angles information.
Clicking an AP shows the clients connected to it (blue lines),
the probing clients that are detected by the AP (red lines), and additional
information such as height, orientation, and X,Y location of the AP.
If you have a Cisco Hyperlocation module that is attached to the
back of your Cisco Aironet 3700 and 3600 Series APs, you can track the location
of customers, visitors, or assets to about one meter in an ideal environment.
Currently, the Hyperlocation solution works for the associated clients only.
to show or hide all the RF interferers that have been detected by the wireless
network, and their zone of impact.
icon to show or hide BLE-transmitting devices that have been detected by the
wireless network. For more information about BLE beacons, see
Managing BLE Beacons.
beacon is detected as an interferer. A common problem faced in the context of
beacons is tracking not being enabled. In such a scenario, you can modify the
tracking configurations using the System service. For more information, see the
Viewing or Tracking Devices.
icon to show or hide Wi-Fi tags. The vendor specific information related to the
tags are displayed in raw format.
icon to filter the display of devices based on parameters such as Connection
Status, Manufacturer, and Service Set Identifier (SSID).
Inclusion & Exclusion
Inclusion & Exclusion
icon to view the inclusion and exclusion regions on a floor. The inclusion and
exclusion regions are created in Cisco Prime Infrastructure. In Cisco CMX, you
can view these regions, but you cannot modify them. The inclusion regions are
shown in green, and the exclusion regions are shown in gray.