t_config_wireless_basic_setup

Available Languages

Updated:January 28, 2019

Bias-Free Language

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.

Basic Wireless Setup

Basic Wireless Setup

On the Configuration > Wireless Setup > Basic page, click Add.

In the Basic Wireless Setup page, perform the following configuration tasks:

Closed General
  1. In the General tab, enter a name for the location.
  2. Enter a description for the location.
  3. Set the Location Type as either Local or Flex.

  4. Use the slider to set Client Density as Low, Typical or High. This plug-in sets the RF characteristics of an AP.

  5. Click Apply.
Closed Wireless Networks
  1. In the Wireless Networks tab, click Add to view the Wireless Network Details page.
  2. Use the WLAN drop-down to select an already configured WLAN or use the Define New link to add the WLAN details.
  3. In the Policy Details section, use the VLAN/VLAN Group drop-down to select the VLAN.
  4. Use the ACL drop-down to select an already configured ACL or use the Define New link to add the ACL details.
  5. Use the QoS drop-down to select the QoS policy to be associated with the WLAN.
  6. Use the sliders to enable Central Switching, Central Authentication, Central DHCP, and Central Association.
  7. Click tick mark to save.
Closed Access Control List
  1. In the ACL tab, click Add to create an ACL.
  2. In the Add ACL Setup window, enter the name of the ACL.
  3. Use the ACL Type drop-down to select the ACL type.
  4. Under the Rules section, enter the sequence number in the Sequence field.
  5. Use the Source Type drop-down to select the source type.
  6. Use the drop-down to select the Action as either Deny or Permit.
  7. Select the Log check box to enable logging.
  8. Click Add.
  9. Click Save & Apply to Device.
Closed AP Provisioning
  1. In the AP Provisioning tab and Add/Select APs section, enter the AP MAC address and click the right arrow to add the AP to the associated list.
  2. Use the search option in the Available AP List to select the APs from the Selected AP list and click the right arrow to add the AP to the associated list.
  3. Click Apply.

 

© 2018 Cisco Systems, Inc. All rights reserved.

 

Was this Document Helpful?

FeedbackFeedback

Contact Cisco

This Document Applies to These Products