t_config_wireless-plus-media-stream

Available Languages

Updated:January 28, 2019

Bias-Free Language

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.

Media Stream

Media Stream

Choose Configuration > Wireless > Media Stream page to configure the following:

ClosedGeneral
  1. In the General tab, check the Multicast Direct Enable check box.
  2. In the Session Message Config section, check the Session Announcement State check box to enable the session announcement mechanism. If the session announcement state is enabled, clients are informed each time a controller is not able to serve the multicast direct data to the client.
  3. In the Session Announcement URL field, enter the URL where the client can find more information when an error occurs during the multicast media stream transmission.
  4. In the Session Announcement Email field, enter the e-mail address of the person who can be contacted.
  5. In the Session Announcement Phone field, enter the phone number of the person who can be contacted.
  6. In the Session Announcement Note field, enter a reason as to why a particular client cannot be served with a multicast media.
  7. Click Apply.
ClosedStreams
  1. In the Streams tab, click Add.
  2. Enter a name for the stream.

  3. Enter the multicast destination start and end IP addresses of the multicast media stream.

    Note: Ensure that the Multicast Destination Start and End IP addresses are of the same type, that is both addresses should be of either IPv4 or IPv6 type.

  4. In the Maximum Expected Bandwidth field, enter the maximum expected bandwidth that you want to assign to the media stream.
  5. In the Resource Reservation Control (RRC) Parameters section, enter the average packet size.
  6. Choose the policy as either admit or deny.
  7. Choose a priority from the Priority drop-down list.
  8. Choose the Violation as either Drop or Fallback.
  9. Click Save & Apply to Device.

 

Related Topics Link IconRelated Topics

 

© 2018 Cisco Systems, Inc. All rights reserved.

 

Was this Document Helpful?

FeedbackFeedback

Contact Cisco

This Document Applies to These Products