t_config_services_network_assurance

Available Languages

Updated:January 28, 2019

Bias-Free Language

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.

Configuring Network Assurance

Configuring Network Assurance

  1. On the Configure > Services > Network Assurance page, choose the required status of Service Status in the Network Assurance Configuration section.
  2. Specify the URL and ID token as required.
  3. In the Provisioning section, specify the appropriate status of Provisioning. If you choose to enable it, then specify the VLAN Interface.
  4. In the Backhaul Configuration section, specify the SSID.
  5. From the Auth Type drop-down list, choose the required authentication type from the following options:
    • Open
    • PSK
    • Dot1X
  6. Click Apply.

 

Related Topics Link IconRelated Topics

 

© 2018 Cisco Systems, Inc. All rights reserved.

 

Was this Document Helpful?

FeedbackFeedback

Contact Cisco

This Document Applies to These Products