t_config_services_cloud_services

Available Languages

Updated:January 22, 2019

Bias-Free Language

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.

Cloud Services

Cloud Services

Choose the Configuration > Services > Cloud Services page to configure the following:

ClosedNetwork Assurance
  1. In the Network Assurance Configuration section, use the slider to enable or disable the Service Status.
  2. Enter a URL, ID token, and port number.
  3. In the Provisioning section, use the slider to enable or disable the Provisioning.
  4. If you enable provisioning, enter a VLAN interface.
  5. In the Backhaul Configuration section, enter the SSID.

  6. From the Auth Type drop-down list, choose one of the following types:

    • Open
    • PSK- If you choose PSK as the Auth Type, select the PSK Format as either Unencrypted or AES, and enter a PSK Key.
    • Dot1x- If you choose Dot1x as the Auth Type, select the EAP-Type, and enter a username and password.
  7. Enter an appropriate password in Enter Password.
  8. Click Apply.
ClosedCMX Cloud
  1. In the CMX Cloud Service Configuration section, check the Enable Service check box.
  2. Enter a service URL, authentication token, HTTP proxy (Hostname or IP), and port number.
  3. Click Apply.

 

© 2018 Cisco Systems, Inc. All rights reserved.

 

Was this Document Helpful?

FeedbackFeedback

Contact Cisco

This Document Applies to These Products