t_config_int_phy_port_settings_config

Available Languages

Updated:January 22, 2019

Bias-Free Language

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.

Configuring Port Configuration Settings for Physical Interfaces

On the Configure > Interface > Physical Interfaces page, the Physical Interface list displays all the interfaces on your device.

To configure settings for a physical interface, select the interface in the list. The Physical Interface Details section is displayed.
Choose a switch mode for the interface. To allow a trunk to be dynamically established between two switch interfaces, choose dynamic auto or dynamic desirable.
If you choose access as the switch mode, enter the access VLAN ID in the Access VLAN field.
If you choose trunk as the switch mode, enter the VLAN IDs you want to assign as trunk links. To allow all VLAN IDs as trunk links, set the Allowed VLANs to All. Specify a native VLAN.
If you choose dynamic auto or dynamic desirableas the switch mode, enter the VLAN IDs you want to assign as trunk links. To allow all VLAN IDs as trunk links, set the Allowed VLANs to All. Specify a native VLAN.
To enable Port Fast, set the field to On.
To enable DHCP snooping for the interface, set the DHCP Snooping field to Enable.
Click Apply.

Was this Document Helpful?

Feedback

Contact Cisco

Open a Support Case
(Requires a Cisco Service Contract)