On the
page, you can specify details in the fields below to view the multicast information for a device.Parameter | Description |
VLAN ID | VLAN identifier |
Broadcast | The broadcast status used to broadcast packets for wireless clients to broadcast traffic for each VLAN. It is disabled by default. |
NonIP-Multicast | The status of the non-IP multicast used for traffic to pass between two non-IP multicast areas. It is enabled by default. |
Multicast | The status of the multicast traffic used for wireless clients. It is disabled by default. |
MGID | The Layer 2 multicast group ID. MGID is generated using the multicast VLAN and multicast IP addresses. |
Parameter | Description |
Index | The multicast index |
MGID | The Layer 3 multicast group ID. MGID is generated using the multicast VLAN and multicast IP addresses. |
S,G,V | The source, group and VLAN corresponding to the MGID value. |
Local Mode
To view the client MAC's supported in Local mode, click Local Mode.
Parameter | Description |
Client MAC | MAC address of the client. |
Stream Name | Name of the media stream. |
IP Address | IP address used for multicast. |
AP-Name | Name of the AP. |
Radio | Name of the radio. |
WLAN | Name of the WLAN. |
QOS | QoS of the client. |
Status | Status |
Flex Connect
To view the client MAC's supported in Flex Connect mode, click Flex Connect.
Parameter | Description |
Client MAC | MAC address of the client |
Stream Name | Name of the Media Stream |
Multicast IP | IP address used for multicast |
AP-Name | Name of the AP |
VLAN ID | VLAN identifier |
Type | Multicast type |
© 2018 Cisco Systems, Inc. All rights reserved.