Adding Mobility Express to Prime
Perform the following steps to add the controllers:
Procedure
Step 1 |
Login to Cisco Prime |
||
Step 2 |
Navigate to Configuration / Network / Network Devices, click on Add Device. |
||
Step 3 |
Enter the IP address of the Mobility Express controller. |
||
Step 4 |
Enter the SNMP Parameters and click Add.
|
||
Step 5 |
After the device is added, it shows up in the All Devices list. |
||
Step 6 |
To view the list of WLANs, navigate to Network Devices > Device Groups > Device Type > Wireless Controller and select the Mobility Express controller you added in Step 4. |
||
Step 7 |
To view the list of AP, navigate to Monitor > Wireless Technologies > Access Point Radios |
||
Step 8 |
To configure WLANS from Prime on Mobility Express, navigate to Configuration > Feature & Technologies under Template. |
||
Step 9 |
Navigate to Controller > WLAN > WLAN Configuration. Enter the Template name and the Template Detail. |
||
Step 10 |
On the Advanced Tab, make sure mDNS profile is set to none as it is not supported on Mobility Express. |
||
Step 11 |
To save the Template, click on ‘Save as New Template’ and select the folder where the teamplates need to be saved. |
||
Step 12 |
To deploy the template to Mobility Express, click Deploy. |
||
Step 13 |
Select the Cisco Mobility Express controller and click OK. |
||
Step 14 |
Navigate to Job Dashboard to view the Job Status |