The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.
This chapter contains the following topics:
Step 1 | To install AP
adder licenses using the CLI, enter the following command:
(Cisco Controller) > license add ap-count <1-200> |
Step 2 | Read the
End User License
Agreement (EULA), type
Y, and press
Enter to
accept:
Feature Name: ap-count Right to Use Enabling additional access points supported by this controller product may require the purchase of supplemental or "adder" licenses. You may remove supplemental licenses from one controller and transfer to another controller in the same product family. NOTE: licenses embedded in the controller at time of shipment are not transferrable. By clicking "I AGREE" (or "I ACCEPT") below, you warrant and represent that you have purchased sufficient supplemental licenses for the access points to be enabled. All supplemental licenses are subject to the terms and conditions of the Cisco end user license agreement (http://www.cisco.com/en/US/docs/general/warranty/English/EU1KEN_.html), together with any applicable supplemental end user license agreements, or SEULA's. Pursuant to such terms, Cisco is entitled to confirm that your access point enablement is properly licensed. If you do not agree with any of the above, do not proceed further and CLICK "DECLINE" below. ACCEPT? [y/n]: Y Successfully added the license. |
Step 3 | The AP adder
licenses are installed and activated on the vWLC. You can view the installed
licenses by typing the
show license
summary command:
(Cisco Controller) > show license summary Feature name: ap_count License type: Evaluation License Eula: Not Accepted Evaluation total period: 12 weeks 6 days License state: Inactive, Not-In-Use RTU License Count: 200 Feature name: ap_count (adder) License type: Permanent License state: Active, Not-In-Use RTU License Count: 200 |
Step 4 | To activate or
deactivate a feature license, enter the following command:
license {activate | deactivate} feature license_name |