t_config_radio_24ghz_network_config

Available Languages

Updated:November 29, 2020

Bias-Free Language

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.

Network

Network

On the Configuration > Radio Configurations > Network page, you can configure network settings for 802.11a/n/ac (5 GHZ) and 802.11b/g/n (2.4 GHZ) radios.

Note: You must disable the radio before you can configure your network settings.

ClosedGeneral Settings
  1. In the General Settings section, based on the radio settings you want to configure, check the required 802.11 Network Status check box to enable the network parameters.
  2. In the Beacon Interval field, enter the rate at which the SSID is broadcast by the AP, from 100 to 600 milliseconds. The default is 100 milliseconds.
  3. In the Fragmentation Threshold (in bytes) field, enter a value between 256 to 2346 bytes. Packets larger than the size you specify here will be fragmented.
  4. Check the DTPC Support check box to advertise the transmit power level of the radio in the beacons and the probe responses. Client devices using dynamic transmit power control (DTPC) receive the channel and power level information from the access points and adjust their settings automatically. For example, a client device used primarily in Japan could rely on DTPC to adjust its channel and power settings automatically when it travels to Italy and joins a network there. You cannot configure a power constraint value on your 802.11a/n/ac (5 GHZ) radio network if the DTPC Supportcheck box is checked.
  5. Check the Tri-Radio Mode check box to enable tri-radio.
  6. Click Apply.
ClosedCCX Location Measurement
  1. In the CCX Location Measurement section, check the Mode check box to globally enable CCX radio management for the network. This parameter causes the APs connected to this device to issue broadcast radio measurement requests to clients running CCX v2 or later releases.
  2. In the Interval field, enter a value to specify how often the APs must issue broadcast radio measurement requests.
  3. Click Apply.
ClosedData Rates
  1. In the Data Rates section, choose a value to specify the rates at which data can be transmitted between the access point and the client:

    • Mandatory—Clients must support this data rate in order to associate to an access point on the controller.

    • Supported—Any associated clients that support this data rate may communicate with the access point using that rate.

    • Disabled—The clients specify the data rates used for communication.

  1. Click Apply.

 

Related Topics Link IconRelated Topics

 

© 2020 Cisco Systems, Inc. All rights reserved.

 

Was this Document Helpful?

FeedbackFeedback

Contact Cisco

This Document Applies to These Products