t_config_discovery_protocols

Available Languages

Updated:November 29, 2020

Bias-Free Language

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.

Configuring Discovery Protocols

Configuring Discovery Protocols

On the Configuration > Layer2 > Discovery Protocols page, you can configure the following:

ClosedCDP
  1. In the CDP tab, use the slider to enable or disable CDP.
  2. Enter a value for hold time. The valid range is between 10 and 255. The default value is 180.
  3. Enter a value for timer. The valid range is between 5 and 254. The default value is 60.
  4. Click Apply to Device.
ClosedLLDP
  1. In the LLDP tab, use the slider to enable or disable LLDP.
  2. Choose TLVs from Enabled list and move it to Disabled list, if required.
  3. Click Apply to Device.

 

© 2020 Cisco Systems, Inc. All rights reserved.

 

Was this Document Helpful?

FeedbackFeedback

Contact Cisco

This Document Applies to These Products